I just "upgraded" to Windows 10. All appeared to go well except for the wireless connection when connected to my Netgear C3000 modem/router. Before the upgrade, it was fine. Since, the wireless has been nothing but wacky, but only when trying to browse the internet, so apparently it's only tcp/ssl traffic. I can hold a Chrome Remote Desktop session for hours and never skip a beat. But, try and bring up a webpage on ANY browser, be it Edge, Chrome, or Firefox, and you're more than likely going to get a page cannot be displayed. Speedtest takes FOREVER to load and run but will never complete the upload speed test. The Dell diagnostic tested the wireless device and passed it, even though it then proceeded to error out on displaying the error report. Then, the kicker, disconnect from the C3000 and connect to my Galaxy S5 as a hotspot, and no problems whatsoever. I've tried the latest driver from Killer Wireless for Windows 10 with no luck. The router has the latest firmware and runs properly with all other devices, it's not the internet provider. I've changed DNS servers to Google's. I've turned off power management to the wireless card. Any other ideas (besides getting another modem and router or reverting back to Windows 8.1)?
↧